January 3rd, and only a dusting of snow on the ground. So many items to check or adjust on the sled, but I need the snow to do it.........
- The engine needs to be ran for some time to verify the oil pump is feeding fuel to the engine (currently I have a 50:1 mix in the tank)
- Verify that coolant is actually pumping through the rails
- Verify clutch/belt engagement: During my one and only ride since getting the sled together the engine rpms were quite high before the belt engage. I cleaned the primary and secondary sheaves with a scotch brite pad, and replaced the drive belt.
Showing posts with label zr600efi. Show all posts
Showing posts with label zr600efi. Show all posts
Sunday, January 3, 2016
Friday, October 9, 2015
Finally, it's running!
Before I get to it running, I will summarize how I cleaned the injectors.
1. I set them in a prescription pill bottle filled with injector cleaner. I put tape around the top so the screens were just below the fluid.
2. Took a 12 volt motorcycle battery, clipped alligator clips to the injector, and briefly cycled each injector 5 or 6 times
3. Blew them off.
The screens were now clean so I assumed the rest was.
Put the injectors back in the sled, dumped in fresh fuel, primed the pump, then crossed my fingers!
It started after about 10 pulls, then quit. I pulled it another 4 times, then it started and kept running! YES!. I shut it off after a minute, waited about 5 minutes, then tried again. It started on the first pull, and I did the same thing 6 times in a row, starting first pull each time!
So, now, besides waiting for snow, I need to double check all my connections, put the hood back on, double-check all the fluid levels, and give it a test run when I can!
Labels:
1998,
98,
carb to efi,
zr 600,
zr 600 efi,
Zr600,
zr600efi
Sunday, June 28, 2015
Major progress
A lot has happened since the rusty bolt. The motor is in. All coolant, oil and fuel lines installed. Well, everything is in but the hood. Primed the fuel pump, but the darn thing wouldn't fire up. I poured a little fuel in each cylinder, and it started on yhe first pull. So, I have a fuel issue. I pulled the supply line from the fuel rail and was able to confirm that there was fuel there. I pulled the injectors, and could see there was not any fuel passing through them. So obviously the injectors were glogged. Next post will be on cleaning the injectors.
Subscribe to:
Posts (Atom)